ACI 315 1999

$91.81

315-99: Details and Detailing of Concrete Reinforcement

Published By	Publication Date	Number of Pages
ACI	1999	44

Guaranteed Safe Checkout

Category: ACI

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

PDF Catalog

PDF Pages	PDF Title
1	CONTENTS Part A Responsibilities of the architect/ engineer Chapter 1 Structural drawings, p. 315- 2 Chapter 2 Standards of practice, p. 315- 3 Part B Responsibilites of the detailer Chapter 3 Placing drawings, p. 315- 10 Chapter 4 Fabricating practice standards, p. 315- 15 Chapter 5 Supports for reinforcing steel, p. 315- 16 Chapter 6 Computer- assisted detailing, p. 315- 16 Chapter 7 Recommended practices for location of bars designated only by size/ spacing, p. 315- 17 Chapter 8 Glossary, p. 31
2	Chapter 10 Notations, p. 315- 19 Part C Figures and tables, p. 315- 20 FOREWORD PART A RESPONSIBILITIES OF THE ARCHITECT/ ENGINEER CHAPTER 1 STRUCTURAL DRAWINGS 1.1 General
3	1.3 Structural drawingsŠ Buildings and other structures 1.4 Structural drawings Highway and transportation structures CHAPTER 2 STANDARDS OF PRACTICE 2.1 General 2.2 Tolerances 2.3 Bar lengths
4	2.4 Hooks and bends 2.5 Beams and girders 2.6 Columns
5	2.7 Development and splices of reinforcing steel
6	2.8 Joint details
7	2.9 Reinforcing steel supports 2.10 Special details for seismic design of frames, joints, walls, diaphragms, and two- way slabs
9	2.11 Corrosion- resistant coatings for reinforcing steel
10	PART B RESPONSIBILITIES OF THE DETAILER CHAPTER 3 PLACING DRAWINGS 3.1 Definition 3.2 Scope 3.3 Procedure 3.4 Drawing standards 3.5 Building drawings
12	3.6 Highway drawings
13	3.7 Detailing to fabricating standards
15	CHAPTER 4 FABRICATING PRACTICE STANDARDS 4.1 Fabrication 4.2 Extras
16	4.3 Tolerances CHAPTER 5 SUPPORTS FOR REINFORCING STEEL 5.1 General 5.2 Types of bar supports 5.3 Side form spacers and beam bolsters 5.4 Placing reinforcing steel supports
17	CHAPTER 6 COMPUTER- ASSISTED DETAILING 6.1 Use of computers in detailing 6.2 Placing drawings 6.3 Ordering procedures CHAPTER 7 RECOMMENDED PRACTICES FOR LOCATION OF BARS DESIGNATED ONLY BY SIZE/ SPACING CHAPTER 8 GLOSSARY
18	CHAPTER 9 REFERENCES 9.1 Referenced standards
19	9.2 Cited references CHAPTER 10 NOTATIONS
20	PART C FIGURES AND TABLES