ASTM-D1429:2008 Edition(Redline)

Specific gravity is an important property of fluids being related to density and viscosity. Knowing the specific gravity will allow determination of a fluid’s characteristics compared to a standard, usually water, at a specified temperature. This will allow the user to determine if the test fluid will be heavier or lighter than the standard fluid.

1. Scope

1.1 These test methods cover the determination of the specific gravity of water and brine free of separable oil, as follows:

1.2 Test Methods A and B are applicable to clear waters or those containing only a moderate amount of particulate matter. Test Method B is preferred for samples of sea water or brines and is more sensitive than Test Method D which has the same general application. Test Method C is intended for samples of water containing mud or sludge.

1.3 It is the user’s responsibility to ensure the validity of these test methods for waters of untested matrices.

1.4 The test method was tested at 22 ° C over a range, shown in Tables 1-4, of 1.0252 through 1.2299; all data were corrected to 15.6 ° C (60 ° F).

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

TABLE 1 Determination of Bias, Pycnometer Method

TABLE 2 Determination of Bias, Balance Method

TABLE 3 Determination of Bias, Erlenmeyer Flask Method

TABLE 4 Determination of Bias, Hydrometer Method

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

D1066 Practice for Sampling Steam D1129 Terminology Relating to Water D1193 Specification for Reagent Water D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water D3370 Practices for Sampling Water from Closed Conduits D5847 Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis E1 Specification for ASTM Liquid-in-Glass Thermometers

Keywords

brine; hydrometer; pycnometer; specific gravity; Brackish water/brines; Specific gravity ;

ICS Code

ICS Number Code 13.060.50 (Examination of water for chemical substances)

DOI: 10.1520/D1429-08 ASTM International is a member of CrossRef.

Citing ASTM Standards

[Back to Top]