ASTM-A530 2012

$40.63

A530/A530M-12 Standard Specification for General Requirements for Specialized Carbon and Alloy Steel Pipe

Published By	Publication Date	Number of Pages
ASTM	2012	9

Guaranteed Safe Checkout

Categories: 23.040.10 - Iron and steel pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers a group of requirements which, with the exceptions of Section 6.3, Section 14, Section 21, and Section 22, are mandatory requirements to the ASTM pipe product specifications noted below unless the product specification specifies different requirements, in which case the requirement of the product specification shall prevail.

1.2 Sections 6.3 or 21 are mandatory if the product specification has a requirement for product analysis or flattening tests.

1.3 Section 22 is mandatory if the product specification has a hydrostatic test requirement without defining the test parameters.

1.4 Section 14 is for information only.

1.5 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification, only the requirement of the product specification need be satisfied.

^A These designations refer to the latest issue of the respective specifications.

1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the M designation (SI) of the product specification is specified in the order.

Note 1The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as nominal diameter, size, and nominal size.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology Ordering Information Process Chemical Composition Mechanical Requirements
3	Tensile Requirements Permissible Variation in Weight Permissible Variations in Wall Thickness Permissible Variations in Inside Diameter Permissible Variations in Outside Diameter Permissible Variations in Length Standard Weight TABLE 1 TABLE 2
4	Ends Straightness Repair by Welding Retests Retreatment Test Specimens Flattening Test Requirements
5	Hydrostatic Test Requirements Material Test Report
6	Inspection Rejection Product Marking Packaging, Marking, and Loading Government Procurement
7	Keywords TABLE 3
8	X1. TABLE OF MINIMUM WALL THICKNESSES TABLE X1.1

Additional information


Centrifugally Cast Carbon Steel Pipe for High- Temperature Service	A660
Electric-Fusion-Welded Steel Pipe for High-Pressure Service at Moderate Temperatures	A672/A672M
Metal-Arc-Welded Steel Pipe for Use With High- Pressure Transmission Systems	A381
Electric-Fusion-Welded Steel Pipe for Atmospheric and Lower Temperatures	A671/A671M
Seamless Carbon Steel Pipe for High-Temperature Service	A106/A106M
Title of Specification	ASTM Designation A
Seamless Carbon Steel Pipe for Atmospheric and Lower Temperatures	A524
Carbon and Alloy Steel Pipe, Electric-Fusion-Welded for High-Pressure Service at High Temperatures	A691/A691M
ICS Codes	23.040.10 - Iron and steel pipes

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-A530 2012

PDF Catalog

Related products