ASTM-C564 2011(Redline)

$23.40

C564-11 Standard Specification for Rubber Gaskets for Cast Iron Soil Pipe and Fittings (Redline)

Published By	Publication Date	Number of Pages
ASTM	2011	5

Guaranteed Safe Checkout

Categories: 23.040.80 - Seals for pipe and hose assemblies, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Abstract

This specification covers preformed rubber gaskets used to seal joints in cast iron soil pipe and fittings. Gaskets shall be made of a properly vulcanized virgin rubber as the sole elastomer with no scrap or reclaim. Gaskets shall conform to the required physical properties such as hardness, elongation, tensile strength, tear strength and compression. The gasket material shall be tested for effects of heat aging. They shall be tested for weight increase due to water absorption and shall also be tested for volume decrease due to oil absorption. Gasket material shall be tested for ozone resistance.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers preformed rubber gaskets used to seal joints in cast iron soil pipe and fittings.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to the test methods section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 The committee with jurisdiction over this standard is not aware of another comparable standard for materials covered in this standard.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

A644 Terminology Relating to Iron Castings C1277 Specification for Shielded Couplings Joining Hubless Cast Iron Soil Pipe and Fittings D395 Test Methods for Rubber Property–Compression Set D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers–Tension D471 Test Method for Rubber Property–Effect of Liquids D573 Test Method for Rubber–Deterioration in an Air Oven D624 Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers D1149 Test Methods for Rubber Deterioration–Cracking in an Ozone Controlled Environment D1415 Test Method for Rubber Property–International Hardness D2240 Test Method for Rubber Property–Durometer Hardness D3677 Test Methods for Rubber–Identification by Infrared Spectrophotometry

Other Documents

CISPI310 Specification for couplings for use in connection with hubless cast iron soil pipe and fittings for sanitary and storm drain, waste, and vent piping applications Available from Cast Iron Soil Pipe Institute (CISPI), http://www.cispi.org.

Keywords

cast iron; fittings; gaskets; pipe; rubber; Cast iron soil pipe/fittings–specifications; Gaskets–specifications; Iron pipe/fittings–specifications; Rubber gaskets;

ICS Code

ICS Number Code 23.040.80 (Seals for pipe and hose assemblies)

DOI: 10.1520/C0564-11 ASTM International is a member of CrossRef.

ASTM C564 (Cast Iron Standards)

Citing ASTM Standards

[Back to Top]

Additional information

Standard Title	C564-11 Standard Specification for Rubber Gaskets for Cast Iron Soil Pipe and Fittings (Redline)
Published Code	ASTM
Publication Date	2011
Pages Count	5
ICS Codes	23.040.80 - Seals for pipe and hose assemblies

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-C564 2011(Redline)

ASTM C564 (Cast Iron Standards)

Related products