BS EN ISO 293:2003
$86.31
Plastics. Compression moulding test specimens of thermoplastic materials
| Published By | Publication Date | Number of Pages |
| BSI | 2003 | 12 |
General principles and procedures for preparing specimens directly or by cutting from moulded sheet. Specifies mould surfaces and conditions and four classified rates of cooling.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 3 | Contents |
| 6 | Foreword |
| 7 | 0 Introduction 1 Scope and field of application 2 References 3 Definitions 3.1 moulding temperature 3.2 demoulding temperature 3.3 preheating time 3.4 moulding time 3.5 average cooling rate |
| 8 | 3.6 cooling rate 4 Apparatus 4.1 Moulding press 4.2 Moulds |
| 9 | 5 Procedure 5.1 Preparation of moulding material |
| 10 | 5.2 Moulding 5.3 Cooling Table Cooling methods |
| 11 | 6 Inspection of the moulded specimens or sheets 7 Test report Types of flash (“picture frame”) moulds Positive-type mould |
