IEEE C63.19 2001
$58.50
American National Standard for Methods of Measurement of Capatibility between Wireless Communication Devices and Hearing Aids
Published By | Publication Date | Number of Pages |
IEEE | 2001 | 103 |
New IEEE Standard – Active. Superseded by ANSI Std C63.19-2005 Uniform methods of measurement for compatibility between hearing aids and wirelesscommunications devices are set forth in this standard.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Cover Page |
2 | Title Page |
4 | Introduction Participants |
6 | CONTENTS |
8 | 1. Overview 1.1 Scope 1.2 Purpose |
9 | 1.3 Organization and use of the document |
12 | 2. References |
15 | 3. Definitions, acronyms, and abbreviations 3.1 Definitions |
18 | 3.2 Acronyms and abbreviations |
19 | 4. Wireless device, RF emissions test 4.1 Test equipment and facilities |
20 | 4.2 Test setup and validation |
21 | 4.3 Near-field test procedure |
29 | 5. Hearing aid RF near-field immunity test |
30 | 5.1 Test facilities and equipment |
31 | 5.2 Test setup and validation |
33 | 5.3 RF immunity test procedure |
38 | 6. Wireless device audio band, magnetic signal test 6.1 Test facilities and equipment |
39 | 6.2 Test configurations and setup |
40 | 6.3 Test procedure for audio band magnetic field |
45 | 7. Performance 7.1 Articulation weighting factor (AWF) 7.2 Audio coupling mode |
47 | 7.3 Audio band magnetic coupling mode |
49 | 7.4 Accessories and options |
50 | 8. Calibration and measurement uncertainty 8.1 General 8.2 Ambient conditions 8.3 Specific calibration requirements 8.4 Measurement uncertainty |
51 | 9. Test report 9.1 Test plan 9.2 Applicable standards 9.3 Equipment unit tested 9.4 Test configuration 9.5 List of test equipment |
52 | 9.6 Units of measurement 9.7 Location of test site 9.8 Measurement procedures 9.9 Reporting measurement data 9.10 General and special conditions |
53 | 9.11 Summary of results 9.12 Required signatures 9.13 Test report annexes 9.14 Test report disposition |
54 | Annex A (normative) Definition of reference axes |
57 | Annex B (normative) Acoustic test frequencies |
58 | Annex C (normative) Equipment and setup calibration |
67 | Annex D (normative) Test equipment specifications |
81 | Annex E (informative) Sample measurement uncertainty estimates |
85 | Annex F (informative) Use of Helmholtz coils for calibration |
94 | Annex G (informative) RF envelope comparison for US WD systems |
97 | Annex H (informative) Explanation of rationale used in this standard |
98 | Annex I (informative) Alternate test method for Rf immunity |
102 | Annex J (informative) Bibliography |