ASME B18.15 2015 R2021

$98.04

ASME B18.15 – 2015(R2021) Forged Eyebolts

Published By	Publication Date	Number of Pages
ASME	2015	22

Guaranteed Safe Checkout

Category: ASME

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This Standard is limited to dimensions and capacities for carbon and stainless steel forged threaded eyebolts in sizes ¼ through 2-1/2 inch for steel and ¼ through 1-1/2” for corrosion resistant stainless steel intended primarily for lifting applications.

PDF Catalog

PDF Pages	PDF Title
4	CONTENTS
5	FOREWORD
6	ASME B18 COMMITTEE ROSTER
7	CORRESPONDENCE WITH THE B18 COMMITTEE
8	1 SCOPE 2 COMPARISON WITH ISO DOCUMENTS 3 REFERENCED STANDARDS 4 DIMENSIONS 5 THREADS
11	6 SHANK LENGTH 7 MATERIAL 7.1 Carbon and Alloy Steel Forged 7.2 Corrosion-Resistant Steel Forged 7.3 Other Materials 8 FINISH 8.1 Steel 8.1.1 8.1.2 8.2 Corrosion-Resistant Steels 9 DESIGNATION 10 QUALITY ASSURANCE 10.1 Defects 10.2 Dimensional Conformance 10.3 Tensile Properties 10.4 Surface Discontinuities 11 MARKING
14	NONMANDATORY APPENDIX A TWO METHODS OF SPECIFYING EYEBOLT CAPACITIES A-1 INTRODUCTION A-2 RIGGERŒS CAPACITY A-3 ENGINEERING CAPACITY Figures Fig. A-1 Uniform Weight Distribution Fig. A-2 Nonuniform Weight Distribution
15	A-4 ADDITIONAL INFORMATION
16	NONMANDATORY APPENDIX B CAUTIONS AND DEFINITIONS B-1 ALTERING OF EYEBOLTS B-2 EXTREME HEAT B-3 HOW TO DESTROY B-4 ALWAYS STAND CLEAR B-5 ELONGATION AND BENDING B-6 DEFINITION OF RATED CAPACITY B-7 DEFINITION OF SAFETY FACTOR
17	NONMANDATORY APPENDIX C APPLICATION INFORMATION C-1 CAPACITY C-2 ANGULAR LIFT C-3 LOAD APPLICATION C-4 TYPE 1 INSTALLATION C-5 TYPE 2 INSTALLATION C-6 RATED CAPACITIES C-7 VISUAL INSPECTION C-8 USE IN TAPPED HOLES Fig. C-1 Load Application
18	C-9 USE IN UNTAPPED HOLES
19	NONMANDATORY APPENDIX D INCH FORGED EYEBOLTS WITH METRIC THREADS D-1 DIMENSIONS D-2 THREADS D-2.1 Thread Dimensions D-2.1.1 D-2.1.2 D-2.2 Thread Acceptance D-3 MATERIALS D-3.1 Carbon and Alloy Steel D-3.2 Corrosion-Resistant Steel D-3.3 Other Materials D-4 METRIC CAPACITY