ASME B18.31.5 2011 R2021

$98.04

ASME B18.31.5 – 2011(R2021) Bent Bolts (Inch Series)

Published By	Publication Date	Number of Pages
ASME	2011	28

Guaranteed Safe Checkout

Category: ASME

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This standard establishes general requirements for parts classified as bent bolts. Dimensional requirements are provided in Tables for U-Bolts of differing bends, Eyebolts, Hook Bolts of differing bends, and J-Bolts. General requirements are provided for Offset Round Bend, J-Bolts, Square Bend Hook Bolts, Vee Bend U-Bolts and Slant U-Bolts. Two methods are identified for designating (ordering) bent bolts covered by this standard. For configurations covered by dimensional tables, Appendix A provides a Part Identification Number System that allows ordering the parts in a number of materials and finishes. For configurations without dimensional requirements or of sizes not covered in the Tables a standard system for identifying the dimensions, material and finish is provided. The inclusion of dimensional data in this standard reflects generally available configurations. It is not intended to imply that all of the products described herein are stock production sizes, particularly in materials other than low carbon steel. Consumers should consult with manufacturers concerning lists of stock production sizes and materials.

PDF Catalog

PDF Pages	PDF Title
6	Foreword
7	Committee Roster
8	Correspondence With The B18 Committee
9	1 Introductory Notes
10	2 General Data
13	Figures 1 Dimensions Of J-bolts, Offset Round Bend 2 Dimensions Of Hook Bolts, Square Bends 3 Dimensions Of U-bolts, Vee Bend 4 Dimensions Of Slant U-bolts
14	Tables Table 1 Dimensions Of U- Bolts, Round Bend
15	Table 2 Dimensions Of U- Bolts, Square Bends
16	Table 3 Dimensions Of Eyebolts, Closed Anchor Ring
17	Table 4 Dimensions Of Eyebolts, Open Anchor Ring
18	Table 5 Dimensions Of Hook Bolts, Right Angle Bend
19	Table 6 Dimensions Of Hook Bolts, Acute Angle Bend Table 7 Dimensions Of Round Bend Hook Bolts
21	Nonmandatory Appendix A Part Identifying Number System For Bent Bolts A- 1 Part Identifying Numbers ( Pins) For Selected Bent Bolts A- 2 The Pin System A- 3 Identification Of Part Numbering System On Drawings
23	Table A- 1 Materials For Bent Bolts
24	Table A- 2 Finish Designations