ASME B31J 2008 R2013
$98.04
ASME B31J Standard Test Method for Determining Stress Intensification Factors (i-Factors) for Metallic Piping Components
| Published By | Publication Date | Number of Pages |
| ASME | 2013 | 20 |
This Standard sets forth an engineering procedure deemed appropriate for the determination of the fatigue capacity of a piping component or joint in most services, relative to a standard butt-welded joint. The B31 piping Codes provide stress intensification factors for the most common piping components and joints. This Standard presents an experimental method to determine stress intensification factors.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 5 | CONTENTS FIGURES TABLE NONMANDATORY APPENDIX |
| 6 | FOREWORD |
| 7 | COMMITTEE ROSTER |
| 8 | CORRESPONDENCE WITH THE B31 COMMITTEE |
| 9 | INTRODUCTION |
| 11 | 1 GENERAL 2 DEFINITIONS 3 TEST PROCEDURE 3.1 Test Equipment 3.2 Test Specimen 3.3 Applied Displacement Calibration |
| 12 | 3.1 Representative Test Arrangement 3.3 Displacement, D, and Force, F, Recorded During Loading and Unloading of a Test Specimen, in Both Positive and Negative Directions, With Linear Displacement |
| 13 | 3.4 Cycles to Leakage 4 STRESS INTENSIFICATION FACTOR 4.1 Calculated Stress 4.2 Section Modulus 4.3 Stress Intensification Factor 4.4 Number of Test Specimens 4.5 Directional Stress Intensification Factors 4.6 Variable Amplitude Test 4.4 Stress Intensification Increase Factor |
| 14 | 5 VARIATIONS IN MATERIALS AND GEOMETRY 5.1 Material Constant and Material Exponent 5.2 Geometric Similarity 6 TEST REPORT |
| 15 | A COMMENTARY ON B31J1 A-1 GENERAL |
| 16 | A-2 REFERENCES |
| 18 | How can you reach us? ItÅ’s easier than ever! |
