ASTM-A325 2009

$40.63

A325-09a Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength

Published By	Publication Date	Number of Pages
ASTM	2009	8

Guaranteed Safe Checkout

Categories: 21.060.10 - Bolts, screws, studs, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A325-09a

Historical Standard: Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength

ASTM A325

Scope

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less and 105 ksi for sizes over 1.0 to 1½ in., inclusive.

1.2 The bolts are intended for use in structural connections. These connections are covered under the requirements of the Specification for Structural Joints Using ASTM A325 or A490 Bolts, approved by the Research Council on Structural Connections, endorsed by the American Institute of Steel Construction and by the Industrial Fastener Institute.

1.3 The bolts are furnished in sizes ½ to 1½ in., inclusive. They are designated by type, denoting chemical composition as follows:

Note 1—Bolts for general applications, including anchor bolts, are covered by Specification A449. Also refer to Specification A449 for quenched and tempered steel bolts and studs with diameters greater than 1½ in. but with similar mechanical properties.

1.4 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 2—A complete metric companion to Specification A325 has been developed—Specification A325M; therefore, no metric equivalents are presented in this specification.

1.5 This specification is applicable to heavy hex structural bolts only. For bolts of other configurations and thread lengths with similar mechanical properties, see Specification A449.

1.6 Terms used in this specification are defined in Terminology F1789.

1.7 The following safety hazard caveat pertains only to the test methods portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

bolts; carbon steel; steel; structural; weathering steel; Bolted construction materials/applications–specifications; High-strength structural steel–specifications; Steel bolting materials–specifications; Structural steel (SS) bolting materials–specifications

ICS Code

ICS Number Code 21.060.10 (Bolts, screws, studs)

DOI: 10.1520/A0325-09A

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Ordering Information
3	Materials and Manufacture Chemical Composition
4	Mechanical Properties Dimensions TABLE 1
5	TABLE 2
6	Workmanship Number of Tests and Retests Test Methods TABLE 3 TABLE 4
7	Inspection Rejection and Rehearing Certification Responsibility Product Marking Packaging and Package Marking TABLE 5 TABLE 6
8	Keywords

Additional information

Type	Description
Type 2	Withdrawn in November 1991.
Type 3	Weathering steel.
Type 1	Medium carbon, carbon boron, or medium carbon alloy steel.
ICS Codes	21.060.10 - Bolts, screws, studs