ASTM-A484 2010

$44.96

A484/A484M-10 Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings

Published By	Publication Date	Number of Pages
ASTM	2010	13

Guaranteed Safe Checkout

Categories: 77.140.20 - Stainless steels, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers general requirements that shall apply to wrought stainless steel bars, shapes, forgings, and billets or other semi-finished material (except wire) for forging, under the latest revision of each of the following ASTM specifications: A276 , A314 , , A473 , , A479/A479M , A564/A564M , A565/A565M , A582/A582M , A638/A638M , A705/A705M , and A831/A831M .

1.2 In the case of conflict between a requirement of a product specification and a requirement of this specification, the product specification shall prevail. In the case of conflict between a requirement of the product specification or a requirement of this specification and a more stringent requirement of the purchase order, the purchase order shall prevail. The purchase order requirements shall not take precedence if they, in any way, violate the requirements of the product specification or this specification; for example, by waiving a test requirement or by making a test requirement less stringent.

1.3 The requirements for introduction of new materials in specifications referencing this specification are given in Annex A1.

1.4 General requirements for flat-rolled stainless steel products other than bar are covered in Specification A480/A480M .

1.5 General requirements for wire products in coils are covered in Specification A555/A555M .

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7 Unless the order specifies an M designation, the material shall be furnished to inch-pound units.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology Ordering Information
3	Materials and Manufacture Chemical Composition Heat Treatment
4	TABLE 1
5	TABLE 2
6	Finish Dimensions, Mass, and Permissible Variations Workmanship, Finish and Appearance Sampling
7	TABLE 3 TABLE 4 TABLE 5
8	Number of Tests and Retests TABLE 6 TABLE 7 TABLE 8
9	Retreatment Test Methods TABLE 9 TABLE 10 TABLE 11 TABLE 12 TABLE 13
10	Inspection TABLE 14 TABLE 15 TABLE 16 TABLE 17 TABLE 18 TABLE 19
11	Rejection and Rehearing Certification Product Marking Packaging and Package Marking Keywords FIG. 1 FIG. 2
12	A1. REQUIREMENTS FOR THE INTRODUCTION OF NEW MATERIALS A1.1 X1. RATIONALE REGARDING DEFINITION OF LOT FOR MECHANICAL PROPERTIES AND CORROSION TESTING X1.1 X1.2 X1.3 X1.4 X2. BAR CODING X2.1

Additional information

Standard Title	A484/A484M-10 Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
Published Code	ASTM
Publication Date	2010
Pages Count	13
ICS Codes	77.140.20 - Stainless steels

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-A484 2010

PDF Catalog

Related products