ASTM-A803 2011
$40.63
A803/A803M-11 Standard Specification for Welded Ferritic Stainless Steel Feedwater Heater Tubes
| Published By | Publication Date | Number of Pages |
| ASTM | 2011 | 7 |
1.1 This specification covers welded ferritic stainless steel feedwater heater tubes including those bent, if specified, into the form of U-tubes for application in tubular feedwater heaters.
1.2 The tubing sizes covered shall be 5 / 8 to 1 in. [15.9 to 25.4 mm] inclusive, in outside diameter, and average or minimum wall thicknesses of 0.028 in. [0.7 mm] and heavier.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the M designation of this specification is specified in the order.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Ordering Information General Requirements Materials and Manufacture Cleaning Before Annealing |
| 2 | Heat Treatment Chemical Composition Mechanical Requirements TABLE 1 |
| 3 | Corrosion Resisting Properties TABLE 2 TABLE 3 TABLE 4 |
| 4 | Workmanship, Finish, and Appearance Surface Condition FIG. 1 TABLE 5 |
| 5 | Nondestructive Test (Electric Test) Inspection Rejection Certification Product Marking Packaging Keywords TABLE 6 |
| 6 | TABLE S1.1 FIG. S1.1 |
| 7 | TABLE S2.1 |
