ASTM-A805 2009
$44.96
A805/A805M-09 Standard Specification for Steel, Flat Wire, Carbon, Cold-Rolled
| Published By | Publication Date | Number of Pages |
| ASTM | 2009 | 12 |
1.1 This specification covers carbon steel flat wire in coils or cut lengths. Flat wire is classified as a cold-rolled section, rectangular in shape, 0.500 in. [12.7 mm] or less in width and under 0.250 in. [6.35 mm] in thickness.
1.2 Low-carbon steel flat wire is produced from steel compositions with a maximum carbon content of 0.25 % by cast or heat analysis.
1.3 Carbon spring steel flat wire is produced to a carbon range in which the specified or required maximum is over 0.25 % by cast or heat analysis.
1.3.1 Two types of carbon spring steel flat wire are produced:
1.3.1.1 Untempered cold-rolled carbon spring steel flat wire, produced to several desirable combinations of properties and
1.3.1.2 Hardened and tempered carbon spring steel wire.
1.4 Definite application flat wire is a product developed for a specific application and may be specified only by size and descriptive name.
1.5 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in non-conformance with this specification.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Ordering Information Materials and Manufacture |
| 3 | Chemical Composition Edge TABLE 1 TABLE 2 TABLE 3 |
| 4 | Dimensional Tolerances Temper and Bend Test Requirement for Low-Carbon Steel Flat Wire Types of Untempered-Carbon Spring Steel Flat Wire TABLE 4 TABLE 5 |
| 5 | Hardness and Tensile Properties of Hardened and Tempered Carbon Spring Steel Flat Wire Coatings Workmanship TABLE 6 TABLE 7 |
| 6 | TABLE 8 TABLE 9 TABLE 10 |
| 7 | Finish and Condition Inspection Rejection and Rehearing Packaging and Package Marking TABLE 11 TABLE 12 |
| 8 | TABLE 13 TABLE 14 |
| 9 | FIG. 1 |
| 10 | X1. GENERAL INFORMATION AND METALLURGICAL ASPECTS X1.1 Aging Phenomenon X1.2 Uncoiling Characteristics of Annealed or Spheroidized Flat Wire X1.3 Definite Application Flat Wire X1.4 Restrictive Requirements |
Related products
-
ASTM-A805 2009(Redline)
A805/A805M-09 Standard Specification for Steel, Flat Wire, Carbon, Cold-Rolled (Redline) Published By Publication Date Number…
