ASTM-B335 2008

ASTM B335

Scope

1.1 This specification covers rod of nickel-molybdenum alloys (UNS N10001, N10665, N10675, N10629, and N10624)* as shown in Table 1, for use in general corrosive service.

1.2 The following products are covered under this specification:

1.2.1 Rods ⁵/₁₆to ¾ in. (7.94 to 19.05 mm) excl in diameter, hot or cold finished, solution annealed and pickled or mechanically descaled.

1.2.2 Rods ¾to 3½ in. (19.05 to 88.9 mm) incl in diameter, hot or cold finished, solution annealed, ground or turned.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

TABLE 1 Chemical Requirements

^A See 12.1

Keywords

rod; N10001; N10624; N10629; N10665; N10675; Nickel alloy rod/bar/wire–specifications; Nickel-molybdenum alloys–specifications; Hastelloy alloy; UNS N10001 (Ni-Mo alloy, Hastelloy B); UNS N10629 (Ni-Mo alloy, B-4); UNS N10665 (Ni-Mo alloy, Hastelloy B-2)

ICS Code

ICS Number Code 77.150.40 (Nickel and chromium products)

DOI: 10.1520/B0335-03R08