ASTM-B593 2020
$40.63
B593-20 Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials
| Published By | Publication Date | Number of Pages |
| ASTM | 2020 | 5 |
ASTM B593-20
Historical Standard: Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials
ASTM B593
Scope
1.1 This test method establishes the requirements for the determination of the reversed or repeated bending fatigue properties of copper alloy flat sheet, or strip of spring materials by fixed cantilever, constant deflection (that is, constant amplitude of displacement)-type testing machines. This method is limited to flat sheet or strip ranging in thickness from 0.005 in. to 0.062 in. (0.13 mm to 1.57 mm), to a fatigue life range of 105 to 108 cycles, and to conditions where no significant change in stress-strain relations occurs during the test.
Note 1: This implies that the load-deflection characteristics of the material do not change as a function of the number of cycles within the precision of measurement. There is no significant cyclic hardening or softening.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazard caveat pertains only to the test methods(s) described in this test method.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
bending fatigue; bending fatigue testing; copper alloy flat strip; copper alloy spring; fatigue testing;
ICS Code
ICS Number Code 77.150.30 (Copper products)
DOI: 10.1520/B0593-20
Related products
-
ASTM-B593 2020(Redline)
B593-20 Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials (Redline) Published By…
