ASTM-C1121:2004 Edition

$35.75

C1121-04 Standard Test Method for Turner and Newall (T and N) Wet-Length Classification of Asbestos

Published By	Publication Date	Number of Pages
ASTM	2004	4

Guaranteed Safe Checkout

Categories: 91.100.40 - Products in fibre-reinforced cement, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM C1121-04

Historical Standard: Standard Test Method for Turner and Newall (T and N) Wet-Length Classification of Asbestos

ASTM C1121

Scope

1.1 This test method covers the operation of the Turner and Newall (T and N) wet sieving classifier for asbestos, and a procedure for the determination of fiber length distribution and fines (defined in Terminology D 2946) content of milled asbestos fiber (-74 μm (200 mesh)) sieve described in Specification E 11.

1.2 For purposes of estimating length distribution, the test is limited to samples free from excessive quantities of non-fibrous particles or contaminants. Quantities exceeding 0.05 g retained in any given length fractions are considered excessive.

1.3 For comparisons between different fiber grades, only those specimens which have approximately the same degree of fiberization as determined by Test Methods D 2752 will give completely meaningful results.

1.4 This test method is not applicable to ultrafine grades of asbestos powders which contain little or no fibers retained on a 74-μm (200 mesh) sieve. This method is restricted to Quebec Standard grades 4A to 7D inclusive as determined by Test Method D 3639.

Note 1—This is an alternative procedure to Test Method D 2589.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Section 7.

Keywords

asbestos; classification; length; length classification; T and N; Turner and Newall; wet length; wet length classification

ICS Code

ICS Number Code 91.100.40 (Products in fibre-reinforced cement)

DOI: 10.1520/C1121-04

Additional information

Standard Title	C1121-04 Standard Test Method for Turner and Newall (T and N) Wet-Length Classification of Asbestos
Published Code	ASTM
Publication Date	2004
Pages Count	4
ICS Codes	91.100.40 - Products in fibre-reinforced cement