ASTM-C158:2007 Edition

$40.63

C158-02(2007) Standard Test Methods for Strength of Glass by Flexure (Determination of Modulus of Rupture)

Published By	Publication Date	Number of Pages
ASTM	2007	9

Guaranteed Safe Checkout

Categories: 81.040.10 - Raw materials and raw glass, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 These test methods cover the determination of the modulus of rupture in bending of glass and glass-ceramics.

1.2 These test methods are applicable to annealed and prestressed glasses and glass-ceramics available in varied forms. Alternative test methods are described; the test method used shall be determined by the purpose of the test and geometric characteristics of specimens representative of the material.

1.2.1 Test Method A is a test for modulus of rupture of flat glass.

1.2.2 Test Method B is a comparative test for modulus of rupture of glass and glass-ceramics.

1.3 The test methods appear in the following order:

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 10 and A1.5, A2.3.3, A2.4.3 and A2.5.3.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Significance and Use Apparatus Test Specimens
3	Procedure FIG. 1 FIG. 2
4	Calculation Report Hazards Test Specimens
5	Test Conditions Procedure Calculation
6	Report Precision and Bias A1. DETERMINATION OF RESIDUAL STRESS A1.1 A1.2 A1.3
7	A1.4 A1.5 Hazards A2. ABRASION PROCEDURES A2.1 Methods of Abrasion A2.2 Aging of Abrasion A2.3 Sandblast Abrasion Procedure for Specimens of Rect-angular Section
8	A2.4 Grit Blast Abrasion for Specimens of Rectangular Section A2.5 Tumble Abrasion Procedure for Specimens of Elliptic Section FIG. A2.1
9	A3. CONVERSION OF UNITS A3.1 REFERENCES