ASTM-C559 2020
$29.79
C559-16(2020) Standard Test Method for Bulk Density by Physical Measurements of Manufactured Carbon and Graphite Articles
| Published By | Publication Date | Number of Pages |
| ASTM | 2020 | 3 |
ASTM C559-16-Reapproved2020
Active Standard: Standard Test Method for Bulk Density by Physical Measurements of Manufactured Carbon and Graphite Articles
ASTM C559
Scope
1.1 This test method covers the determination of the bulk density of manufactured articles of carbon and graphite of at least 500 mm3 volume. The bulk density is calculated to an accuracy of 0.25 %, using measurements of mass and dimensions in air at 25 °C ± 5 °C.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
bulk; carbon density; graphite; gravimetric; physical;
ICS Code
ICS Number Code 71.100.99 (Other products of the chemical industry)
DOI: 10.1520/C0559-16R20
