ASTM-D2463 2023

$34.13

D2463-23 Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers

Published By	Publication Date	Number of Pages
ASTM	2023	5

Guaranteed Safe Checkout

Categories: 83.080.20 - Thermoplastic materials, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D2463-23

Active Standard: Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers

ASTM D2463

Scope

1.1 This test method provides a means to assess the drop impact resistance of water-filled, blow-molded thermoplastic containers, which is a summation of the effects of material, manufacturing conditions, container design, and perhaps other factors.

1.2 Two procedures are provided as follows:

1.2.1 Procedure A, Static Drop Height Method—This procedure is particularly useful for quality control since it is quick.

1.2.2 Procedure B, Bruceton Staircase Method—This procedure is used to determine the mean failure height and the standard deviation of the distribution.

1.3 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.

Note 1: There is no known ISO equivalent to this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

blow-molded containers; drop impact; plastic containers;

ICS Code

ICS Number Code 83.080.20 (Thermoplastic materials)

DOI: 10.1520/D2463-23

Additional information

Standard Title	D2463-23 Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers
Published Code	ASTM
Publication Date	2023
Pages Count	5
ICS Codes	83.080.20 - Thermoplastic materials