ASTM-D3000 1995
$40.63
D3000-95ae1 Standard Specification for Polybutylene (PB) Plastic Pipe (SDR-PR) Based on Outside Diameter (Withdrawn 2003)
| Published By | Publication Date | Number of Pages |
| ASTM | 1995 | 5 |
ASTM D3000-95ae1
Withdrawn Standard: Standard Specification for Polybutylene (PB) Plastic Pipe (SDR-PR) Based on Outside Diameter (Withdrawn 2003)
ASTM D3000
Scope
1.1 This specification covers polybutylene (PB) pipe that is outside diameter controlled, made in standard thermoplastic pipe dimension ratios, and pressure rated for water (see Appendix). Included are criteria for classifying PB plastic pipe materials and PB plastic pipe, a system of nomenclature for PB plastic pipe, and requirements and methods of test for materials, workmanship, dimensions, sustained pressure, and burst pressure. Methods of marking are also given.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Polybutylene (PB) pipe; SDR-PR pipe, outside diameter-controlled
ICS Code
ICS Number Code 23.040.20 (Plastic pipes)
DOI: 10.1520/D3000-95AE01
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Pipe Classification Materials Requirements Test Methods TABLE 1 |
| 3 | TABLE 2 TABLE 3 TABLE 4 |
| 4 | Retest and Rejection Marking Quality Assurance TABLE 5 |
| 5 | X1. SOURCE OF HYDROSTATIC DESIGN STRESSES X1.1 X1.2 X1.3 X1.4 TABLE X1.1 |
