ASTM-D3921:2011 Edition

$40.63

D3921-96(2011) Standard Test Method for Oil and Grease and Petroleum Hydrocarbons in Water

Published By	Publication Date	Number of Pages
ASTM	2011	7

Guaranteed Safe Checkout

Categories: 13.060.50 - Examination of water for chemical substances, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D3921-96-Reapproved2011

Withdrawn Standard: Standard Test Method for Oil and Grease and Petroleum Hydrocarbons in Water (Withdrawn 2013)

ASTM D3921

Scope

1.1 This test method covers the determination of fluorocarbon-extractable substances as an estimation of the combined oil and grease and the petroleum hydrocarbon contents of a sample of water or waste water in the range from 0.5 to 100 mg/L. It is the user’s responsibility to assume the validity of the standard for untested types of water.

1.2 This test method defines oil and grease in water and waste water as that matter which is extractable in the test method and measured by infrared absorption. Similarly, this test method defines petroleum hydrocarbons in water and waste water as that oil and grease which is not adsorbed by silica gel in the test method and that is measured by infrared absorption.

1.3 Low-boiling organic materials are lost by evaporation during the manipulative transfers. However, these evaporative losses are generally much lower than those experienced with gravimetric procedures that require solvent evaporation before the residue is weighed.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

oil and grease; petroleum hydrocarbons; Fluorocarbon content; Grease content–water; Hydrocarbon content; Oil content; Organic compounds–water; Petroleum products; Wastewater testing/treatment

ICS Code

ICS Number Code 13.060.50 (Examination of water for chemical substances)

DOI: 10.1520/D3921-96R11

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Interferences Apparatus Reagents Sampling Calibration
3	Procedure
4	FIG. 1
5	Calculation Precision and Bias
6	Quality Assurance/Quality Control Keywords X1. EXAMPLE CALCULATIONS FOR QUALITY ASSURANCE/QUALITY CONTROL (QA/QC) STATISTICS X1.1 X1.2 Calculation of Precision and Bias Criteria for the Initial Demonstration of Proficiency TABLE 1
7	X1.3 Calculation of Bias Criteria for Quality Control Samples

Additional information

Standard Title	D3921-96(2011) Standard Test Method for Oil and Grease and Petroleum Hydrocarbons in Water
Published Code	ASTM
Publication Date	2011
Pages Count	7
ICS Codes	13.060.50 - Examination of water for chemical substances