ASTM-D4026 2012

ASTM D4026

Scope

1.1 This test method covers the determination of the residual styrene content of styrene butadiene (SBR) latex. This test method is based upon direct injection of a diluted latex into a gas chromatograph. The amount of residual styrene is calculated using an internal standard technique.

1.2 The range of residual styrene covered is approximately 100 to 3000 mg/kg (ppm) with a lower detection limit of approximately 50 mg/kg (ppm).

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific safety statements, see Section 8.)

Keywords

styrene; styrene-butadiene rubber (SBR); styrene-butadiene rubber latex; Chemical analysis–rubber chemicals/materials; Gas chromatography (GC)–rubber products/applications; Natural rubber (NR) latex; Residual styrene content; SBR (styrene-butadiene rubber); Styrene content

ICS Code

ICS Number Code 83.040.10 (Latex and raw rubber)

DOI: 10.1520/D4026-06R12