ASTM-D4389 2004
$40.63
D4389-04 Standard Specification for Finished Glass Fabrics Woven From Rovings
Published By | Publication Date | Number of Pages |
ASTM | 2004 | 5 |
ASTM D4389-04
Historical Standard: Standard Specification for Finished Glass Fabrics Woven From Rovings
ASTM D4389
Scope
1.1 This specification primarily covers glass fabrics woven from “E” electrical continuous glass fiber rovings that are intended primarily as a reinforcing material in laminated plastics for structural use.
1.2 This specification specifies the terminology, definitions, general requirements, and physical requirements for woven roving glass fiber fabrics. This specification permits the application of sizing materials to the glass fiber roving during manufacture that helps facilitate weaving. When used as permitted in this specification, such materials are compatible with the resin matrix as specified in the contracting instrument. Note 1Sizing materials on glass fiber yarns, in most cases, are removed by various cleaning procedures as a first stage in preparing a finished fabric. When these yarn sizing materials are removed during a cleaning procedure, they need not be compatible with the subsequent resin matrix.
1.3 The values stated in either SI units or inch-pound units are to be regarded as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.Note 2This specification is one of a series to provide a substitute for the following Military Specifications: MIL-Y-1140H Yarn, Cord, Sleeving, Cloth, and Tape-Glass MIL-C-9084C Cloth, Glass Finished for Resin Laminates MIL-C-19663C Cloth, Glass, Woven Roving for Plastic Laminates
Keywords
appearance; construction; fabric count; glass woven roving; ignition loss; length; mass per unit area; width
ICS Code
ICS Number Code 59.100.10 (Textile glass materials)
DOI: 10.1520/D4389-04
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology Classification |
2 | Material Fabric Count Yarn Designations Yarn Number Filament Diameter Strand Construction Weave Type Mass per Unit Area Width Length TABLE 1 TABLE 2 |
3 | Ignition Loss Fabric Appearance Put-Up Packaging Marking Sampling TABLE 3 |
4 | Condition Material Fabric Count Yarn Number Filament Diameter Strand Construction Fabric Weave Type Mass per Unit Area Width Length Finish and Ignition Loss Fabric Appearance Put-Up, Packaging, and Marking Conformance TABLE 4 |
5 | Keywords |