ASTM-D4476 2003

ASTM D4476

Scope

1.1 This test method covers the determination of the flexural properties of fiber-reinforced pultruded plastic rods. The specimen is a rod with a semicircular cross section, molded or cut from lengths of pultruded rods (see ). This test method is designed for rods with a diameter of 1/2 in. or greater.

Note 1—There is no ISO equivalent for this standard.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

flexural properties; plastic rods; pultruded products; thermosetting plastics

ICS Code

ICS Number Code 83.120 (Reinforced plastics)

DOI: 10.1520/D4476-03