ASTM-D471:2006 Edition

$44.96

D471-06 Standard Test Method for Rubber Property-Effect of Liquids

Published By	Publication Date	Number of Pages
ASTM	2006	13

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers the required procedures to evaluate the comparative ability of rubber and rubber-like compositions to withstand the effect of liquids. It is designed for testing: ( 1 ) specimens of vulcanized rubber cut from standard sheets (see Practice D 3182), ( 2 ) specimens cut from fabric coated with vulcanized rubber (see Test Methods D 751), or ( 3 ) finished articles of commerce (see Practice D 3183). This test method is not applicable to the testing of cellular rubbers, porous compositions, and compressed sheet packing, except as described in 11.2.2.

1.2 ASTM Oils No. 2 and No. 3, formerly used in this test method as standard test liquids, are no longer commercially available and in 1993 were replaced with IRM 902 and IRM 903, respectively (see Appendix X1 for details).

1.3 ASTM No. 1 Oil, previously used in this test method as a standard test liquid, is no longer commercially available and in 2005 was replaced with IRM 901; refer to , Footnote A, and Appendix X3 for details.

1.4 This test method includes the following:

1.5 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Summary of Test Method Significance and Use Test Conditions TABLE 1
3	Standard Test Liquids TABLE 2 TABLE 3 TABLE 4
4	Preparation of Specimen Apparatus Test Specimens—Change in Mass or Volume Procedure for Change in Mass
5	Procedure for Change in Volume FIG. 1
6	Dimensional-Change Method for Water-Insoluble Liquids and Mixed Liquids Procedure for Change in Mass with Liquid on One Surface Only FIG. 2
7	Procedure for Determining Mass of Soluble Matter Extracted by the Liquid Changes in Tensile Strength, Elongation, and Hardness Changes in Breaking Resistance, Burst Strength, Tear Strength, and Adhesion for Coated Fabrics
8	Calculation
9	Report Precision and Bias
10	Keywords TABLE 5
11	X1. REPLACEMENT OF ASTM OILS NO. 2 AND NO. 3 WITH IRM 902 AND IRM 903 X1.1 X1.2 TABLE 6
12	X1.3 X2. PRECISION AND BIAS—TEST PROGRAM FOR THE REPLACEMENT OF ASTM OILS NO. 2 & NO. 3 X2.1 X2.2 X2.3 X2.4 X2.5 X2.6 TABLE X2.1
13	X3. REPLACEMENT OF ASTM OIL NO. 1 WITH IRM 901 X3.1