ASTM-D5485 2009
$44.96
D5485-09 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
| Published By | Publication Date | Number of Pages |
| ASTM | 2009 | 14 |
1.1 This fire-test-response standard measures the corrosive effect by loss of metal from the combustion products of materials, components, or products.
1.2 This test method provides corrosion results of product and material specimens limited to a maximum size of 100 by 100 mm in area and 50 mm thick.
1.3 The results of this test method have not been investigated with respect to correlation to actual fires.
1.4 This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.
1.4.1 Additional information regarding the targets, the test conditions, and test limitations are provided in the annex.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. (See IEEE/ASTM SI-10 )
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Summary of Test Method Significance and Use Interferences FIG. 1 |
| 3 | Apparatus FIG. 2 |
| 4 | FIG. 3 FIG. 4 |
| 5 | FIG. 5 |
| 6 | FIG. 6 |
| 7 | FIG. 7 |
| 8 | FIG. 8 |
| 9 | FIG. 9 FIG. 10 |
| 10 | Hazards Test Specimens Calibration of Apparatus FIG. 11 |
| 11 | Equipment and Specimen Preparation Procedure |
| 12 | Calculation Report Precision and Bias Keywords |
| 13 | A1. Discussion on the Important Factors in the Measurement of Corrosion Using the Cone Corrosimeter A1.1 Introduction A1.2 Corrosion Measurements A1.3 Gas Sampling Design |
| 14 | A1.4 Use of Data |
