ASTM-D5592 2010

$40.63

D5592-94(2010) Standard Guide for Material Properties Needed in Engineering Design Using Plastics

Published By	Publication Date	Number of Pages
ASTM	2010	6

Guaranteed Safe Checkout

Categories: 83.080.01 - Plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This guide covers the essential material properties needed for designing with plastics. Its purpose is to raise the awareness of the plastics community regarding the specific considerations involved in using the appropriate material properties in design calculations.

1.2 This guide is intended only as a convenient resource for engineering design. It should be noted that the specific operating conditions (temperature, applied stress or strain, environment, etc. and corresponding duration of such exposures) could vary significantly from one application to another. It is, therefore, the responsibility of the user to perform any pertinent tests under actual conditions of use to determine the suitability of the material in the intended application.

1.3 The applicable ISO and ASTM standard methods for the relevant material properties are listed in this guide for the benefit of design engineers.

1.4 It should be noted that for some of the desired properties, no ASTM or ISO standards exist. These include pvT data, no-flow temperature, ejection temperature, and fatigue in tension. In these instances, relying on available test methods is suggested.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1There is no similar or equivalent ISO standard.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology
3	Significance and Use Material Properties in Engineering Design
4	Data Reporting Format TABLE 1
5	Keywords TABLE 2

Additional information

Standard Title	D5592-94(2010) Standard Guide for Material Properties Needed in Engineering Design Using Plastics
Published Code	ASTM
Publication Date	2010
Pages Count	6
ICS Codes	83.080.01 - Plastics in general

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D5592 2010

PDF Catalog

Related products