ASTM-D5670 2004
$40.63
D5670-95(2004)e1 Standard Test Method for Rubber-Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by Infrared Spectrophotometry
| Published By | Publication Date | Number of Pages |
| ASTM | 2004 | 5 |
1.1 This test method, based on infrared examination of rubber films cast from solution, covers the percentage of residual unsaturation (double bonds in unhydrogenated butadiene) in hydrogenated nitrile rubber.
1.2 This test method is applicable to all grades of hydrogenated nitrile rubber in the raw state.
1.3 This test method assumes that specimens and infrared spectra are prepared and analyzed by experienced personnel and that the equipment is operated according to the manufacturer’s direction for optimum performance. No details for operation of infrared spectrophotometers are included in this test method.
1.4 Since it is customary in infrared spectrophotometry to use wavenumbers (cm -1 ) rather than Hertz (Hz), the unit for frequency in the SI system, the former is employed throughout this test method.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Summary of Test Method Significance and Use |
| 2 | Apparatus Reagents Procedure |
| 3 | Limitation Report Precision and Bias Keywords TABLE 1 |
| 4 | X1. EXAMPLE X1.1 X1.2 TABLE X1.1 FIG. X1.1 |
| 5 | FIG. X1.2 |
Related products
-
ASTM-D5640 2008
D5640-95(2008) Standard Guide for Selection of Weirs and Flumes for Open-Channel Flow Measurement of Water…
-
ASTM-D5660 2004
D5660-96(2004) Standard Test Method for Assessing the Microbial Detoxification of Chemically Contaminated Water and Soil…
-
ASTM-D5660 2009
D5660-96(2009) Standard Test Method for Assessing the Microbial Detoxification of Chemically Contaminated Water and Soil…
-
ASTM-D5607 2008
D5607-08 Standard Test Method for Performing Laboratory Direct Shear Strength Tests of Rock Specimens Under…
-
ASTM-D5760 2005
D5760-05 Standard Specification for Performance of Manual Transmission Gear Lubricants Published By Publication Date Number…
-
ASTM-D5600 2004
D5600-04 Standard Test Method for Trace Metals in Petroleum Coke by Inductively Coupled Plasma Atomic…
-
ASTM-D5600 2004
D5600-04e1 Standard Test Method for Trace Metals in Petroleum Coke by Inductively Coupled Plasma Atomic…
-
ASTM-D5640 2003
D5640-95(2003) Standard Guide for Selection of Weirs and Flumes for Open-Channel Flow Measurement of Water…
-
ASTM-D5070 2005
D5070-90(2005) Standard Test Method for Synthetic Quaternary Ammonium Salts in Fabric Softeners by Potentiometric Titrations…
-
ASTM-D5680 2001
D5680-95a(2001) Standard Practice for Sampling Unconsolidated Solids in Drums or Similar Containers Published By Publication…
-
ASTM-D2670 2004
D2670-95(2004) Standard Test Method for Measuring Wear Properties of Fluid Lubricants (Falex Pin and Vee…
-
ASTM-D5630 2001
D5630-01 Standard Test Method for Ash Content in Thermoplastics Published By Publication Date Number of…
-
ASTM-D5970 2009(Redline)
D5970-09 Standard Test Method for Deterioration of Geotextiles from Outdoor Exposure (Redline) Published By Publication…
-
ASTM-D5370 2006(Redline)
D5370-06 Standard Specification for Pozzolanic Blended Materials in Construction Applications (Redline) Published By Publication Date…
-
ASTM-D5600 2003
D5600-98(2003) Standard Test Method for Trace Metals in Petroleum Coke by Inductively Coupled Plasma Atomic…
-
ASTM-D5070 2014
D5070-90(2014) Standard Test Method for Synthetic Quaternary Ammonium Salts in Fabric Softeners by Potentiometric Titrations…
-
ASTM-D3670 2007
D3670-91(2007) Standard Guide for Determination of Precision and Bias of Methods of Committee D22 Published…
-
ASTM-D3670 2007(Redline)
D3670-91(2007) Standard Guide for Determination of Precision and Bias of Methods of Committee D22 (Redline)…
-
ASTM-D5470 2001
D5470-01 Standard Test Method for Thermal Transmission Properties of Thin Thermally Conductive Solid Electrical Insulation…
-
ASTM-D5670 2014
D5670-95(2014) Standard Test Method for Rubber—Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by…
-
ASTM-D5370 2006
D5370-06 Standard Specification for Pozzolanic Blended Materials in Construction Applications Published By Publication Date Number…
-
ASTM-D5760 2009(Redline)
D5760-09 Standard Specification for Performance of Manual Transmission Gear Lubricants (Redline) Published By Publication Date…
-
ASTM-D5670 2000
D5670-95(2000)e1 Standard Test Method for Rubber-Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by…
-
ASTM-D5270 2008
D5270-96(2008) Standard Test Method for Determining Transmissivity and Storage Coefficient of Bounded, Nonleaky, Confined Aquifers…
-
ASTM-D5650 2007
D5650-97(2007) Standard Test Method for Resistance to Bending of Paper of Low Bending Stiffness (Taber-Type…
-
ASTM-D5670 2009
D5670-95(2009) Standard Test Method for Rubber-Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by…
-
ASTM-D6570 2004
D6570-04e1 Standard Practice for Assigning Allowable Properties for Mechanically Graded Lumber Published By Publication Date…
-
ASTM-D5675 2004
D5675-04 Standard Specification for Fluoropolymer Micropowders Published By Publication Date Number of Pages ASTM 2004…
-
ASTM-D6670 2001
D6670-01 Standard Practice for Full-Scale Chamber Determination of Volatile Organic Emissions from Indoor Materials/Products Published…
-
ASTM-D5970 2009
D5970-09 Standard Test Method for Deterioration of Geotextiles from Outdoor Exposure Published By Publication Date…
-
ASTM-D5607 2006
D5607-02(2006) Standard Test Method for Performing Laboratory Direct Shear Strength Tests of Rock Specimens Under…
-
ASTM-D5270 2002
D5270-96(2002) Standard Test Method for Determining Transmissivity and Storage Coefficient of Bounded, Nonleaky, Confined Aquifers…
-
ASTM-D5620 2004
D5620-94(2004) Standard Test Method for Evaluating Thin Film Fluid Lubricants in a Drain and Dry…
-
ASTM-D5674 2008
D5674-95(2008) Standard Guide for Operation of a Gaging Station Published By Publication Date Number of…
-
ASTM-D6570 2004
D6570-04 Standard Practice for Assigning Allowable Properties for Mechanically-Graded Lumber Published By Publication Date Number…
-
ASTM-D5679 2006
D5679-95a(2006) Standard Practice for Sampling Consolidated Solids in Drums or Similar Containers Published By Publication…
-
ASTM-D5680 2014(Redline)
D5680-14 Standard Practice for Sampling Unconsolidated Solids in Drums or Similar Containers (Redline) Published By…
-
ASTM-D5600 2009
D5600-09 Standard Test Method for Trace Metals in Petroleum Coke by Inductively Coupled Plasma Atomic…
-
ASTM-D5600 2014(Redline)
D5600-14 Standard Test Method for Trace Metals in Petroleum Coke by Inductively Coupled Plasma Atomic…
-
ASTM-D5674 2003
D5674-95(2003) Standard Guide for Operation of a Gaging Station Published By Publication Date Number of…
