ASTM-D5853 2009

$40.63

D5853-09 Standard Test Method for Pour Point of Crude Oils

Published By	Publication Date	Number of Pages
ASTM	2009	7

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D5853-09

Historical Standard: Standard Test Method for Pour Point of Crude Oils

ASTM D5853

Scope

1.1 This test method covers two procedures for the determination of the pour point temperatures of crude oils down to −36°C. Procedure A provides a measure of the maximum (upper) pour point temperature and is described in 9.1. Procedure B provides a measure of the minimum (lower) pour point temperature and is described in 9.2.

1.2 The use of this test method is limited to use for crude oils. Pour point temperatures of other petroleum products can be determined by Test Method D 97.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.

Keywords

cold flow; crude oil; pour point; Cold flow; Crude petroleum products; Maximum pour point temperature; Minimum pour point temperature; Pour point–petroleum products

ICS Code

ICS Number Code 75.040 (Crude petroleum)

DOI: 10.1520/D5853-09

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Apparatus FIG. 1
3	Reagents and Materials Sampling, Test Samples, and Test Specimens Procedure TABLE 1
4	FIG. 2
5	Calculation and Report Precision and Bias Keywords
6	X1. GUIDELINE FOR SAMPLE HANDLING X1.1 Introduction X1.2 Heating of Samples X1.3 Homogenization of Samples