ASTM-D5963 2004
$40.63
D5963-04 Standard Test Method for Rubber Property—Abrasion Resistance (Rotary Drum Abrader)
| Published By | Publication Date | Number of Pages |
| ASTM | 2004 | 9 |
ASTM D5963-04
Historical Standard: Standard Test Method for Rubber Property—Abrasion Resistance (Rotary Drum Abrader)
ASTM D5963
Scope
1.1 This test method covers the measurement of abrasion resistance of rubbers (vulcanized thermoset rubbers and thermoplastic elastomers) that are subject to abrasive/frictional wear in actual service. The abrasion resistance is measured by moving a test piece across the surface of an abrasive sheet mounted to a revolving drum, and is expressed as volume loss in cubic millimetres or abrasion resistance index in percent. For volume loss, a smaller number indicates better abrasion resistance, while for the abrasion resistance index, a smaller number denotes poorer abrasion resistance.
1.2 Test results obtained by this test method shall not be assumed to represent the wear behavior of rubber products experienced in actual service.
1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
abrader; abrasion; abrasion resistance; abrasion resistance index; abrasion test; abrastion tester; ARI; frictional wear; mass loss; rotary drum abrader; rotating drum abrader; volume loss; wear behavior
ICS Code
ICS Number Code 19.060 (Mechanical testing)
DOI: 10.1520/D5963-04
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Summary of Test Method Significance and Use Limitations Apparatus and Materials |
| 3 | FIG. 1 FIG. 2 |
| 4 | Standard Rubber Preparation of Test Specimens Procedure FIG. 3 |
| 5 | Determination of Abrasiveness of the Abrasive Sheet Calculation of Test Results |
| 6 | Test Report Precision and Bias TABLE 1 |
| 7 | Keywords A1. STANDARD RUBBERS FORMULA, MIXING, VULCANIZATION, AND COMPLIANCE TESTING A1.1 Preparation of Standard Rubber #1 for Method A and Method B TABLE 2 TABLE 3 TABLE A1.1 |
| 8 | A1.2 Preparation of Standard Rubber #2 for Method C and Method D A1.3 Compliance Testing for Mass Loss TABLE A1.2 TABLE A1.3 |
| 9 | X1. BACKGROUND INFORMATION X1.1 X1.2 |
