ASTM-D6034 2010
$40.63
D6034-96(2010)e1 Standard Test Method (Analytical Procedure) for Determining the Efficiency of a Production Well in a Confined Aquifer from a Constant Rate Pumping Test
Published By | Publication Date | Number of Pages |
ASTM | 2010 | 8 |
1.1 This test method describes an analytical procedure for determining the hydraulic efficiency of a production well in a confined aquifer. It involves comparing the actual drawdown in the well to the theoretical minimum drawdown achievable and is based upon data and aquifer coefficients obtained from a constant rate pumping test.
1.2 This analytical procedure is used in conjunction with the field procedure, Test Method D4050 .
1.3 The values stated in inch-pound units are to be regarded as standard, except as noted below. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.3.1 The gravitational system of inch-pound units is used when dealing with inch-pound units. In this system, the pound (lbf) represents a unit of force (weight), while the unit for mass is slugs.
1.4 Limitations The limitations of the technique for determination of well efficiency are related primarily to the correspondence between the field situation and the simplifying assumption of this test method.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | Scope Referenced Documents Terminology |
2 | Summary of Test Method FIG. 1 |
4 | Significance and Use Apparatus Procedure Calculation and Interpretation of Test Data FIG. 2 |
5 | TABLE 1 FIG. 3 |
6 | FIG. 4 FIG. 5 TABLE 2 |
7 | Report Precision and Bias Keywords REFERENCES FIG. 6 |