ASTM-D6037 2008

$35.75

D6037-96(2008) Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings

Published By	Publication Date	Number of Pages
ASTM	2008	4

Guaranteed Safe Checkout

Categories: 25.220.01 - Surface treatment and coating in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 Two test methods are included. Test Method A uses a device that contains an abrasive wheel. Test Method B uses a device that contains a wheel that has been fitted with abrasive paper. Either method can be used to evaluate the dry abrasion mar resistance of coatings applied to planar, rigid surfaces. Each test method provides good discrimination between highly mar resistant coatings.

1.2 Mar resistance is assessed by measuring the gloss of abraded and unabraded areas. Mar resistance is directly related to the coating’s ability to retain gloss in abraded areas.

Note 1The mar resistance values obtained by these test methods have no absolute significance. They should only be used to derive relative performance rankings for test panels that have been prepared from the series of coatings that are currently being evaluated. If mar resistance values are quoted between laboratories, it is essential that a common standard be measured and that the values be compared to that standard. Even then, the values should be used with caution.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Apparatus Preparation of Specimens Conditioning Procedure
3	Report Precision and Bias Apparatus Preparation of Specimens Conditioning Procedure FIG. 1
4	Report Precision and Bias Keywords

Additional information

Standard Title	D6037-96(2008) Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings
Published Code	ASTM
Publication Date	2008
Pages Count	4
ICS Codes	25.220.01 - Surface treatment and coating in general

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D6037 2008

PDF Catalog

Related products