ASTM-D6201:2001 Edition

$58.50

D6201-01 Standard Test Method for Dynamometer Evaluation of Unleaded Spark-Ignition Engine Fuel for Intake Valve Deposit Formation

Published By	Publication Date	Number of Pages
ASTM	2001	11

Guaranteed Safe Checkout

Categories: 75.160.20 - Liquid fuels, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method coves an engine dynamometer test procedure for evaluation of intake valve deposit formation of unleaded spark-ignition engine fuels. This test uses a Ford Ranger 2.3 L four-cylinder engine. The following details the procedure, hardware, and operations used for this test.

1.2 The ASTM Test Monitoring Center (TMC) is responsible for engine test stand certification as well as issuance of information letters after test method modifications are approved by Subcommittee D02.A and Committee D02. Users of this test method shall request copies of recent information letters from the TMC to ensure proper conduct of the test method.

1.3 The values stated in SI units are to be regarded as the standard. Approximate inch-pound units are shown in parenthesis for information.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine applicability of regulatory limitations prior to use. Specific precautionary statements are given throughout this test method.

1.4 This test method is arranged as follows:

Additional information

Specific Hazards	8.1
Engine Part Number Listing	Annex A2
Determination of Test Results	13
Photographs of Parts - General	13.2
Special Measurement and Assembly Equipment	6.4
Reference Fuel	9
Standard Report	14.1
Precision and Bias	15
Instrumentation Calibration	11.2
Fuel Batch Analyses	9.2
Engine Oil and Assembly Lubricant	7.2
Laboratory Facilities	6.1
Valve Lapping Compound	7.6
Periodic Measurements and Functions	12.3
Photographs of Specific Parts	14.3
Calibration	11
Subject	Section
Test Stand Laboratory Equipment	6.2
Final Test Report	14
Solvents and Cleaners	7.4
Crushed Walnut Shells	7.7
Scope	1
Fuel	7.1
Engine Block Preparation	10.2
Test Procedure	12
Pretest Procedure	12.1
Engine Operating Procedure	12.2
Bias	15.2
Cylinder Head Preparation	10.4
Fuel Injector Test Fluid	7.5
Final Engine Assembly	10.7
Referenced Documents	2
End of Test Procedures	12.4
Fuel Batch Shipment and Storage	9.3
Desiccant	7.8
Test Stand Calibration	11.1
Summary of Test Method	4
Determination of Test Validity - Engine Conformance	13.4
Data Acquisition Summary Report	14.2
Apparatus	6
Cylinder Head Assembly	10.5
Post-test Intake Valve Weighing Procedure	13.1
Engine Coolant	7.3
Hazards	8
Test Engine Hardware	6.3
Significance and Use	5
Precision	15.1
Induction System Rating	13.3
Preparation of Apparatus	10
Test Stand Preparation	10.1
Preparation of Miscellaneous Engine Components	10.3
Reagents and Materials	7
Reference Base Fuel Batch Approval Process	9.1
Terminology	3
Cylinder Head Installation	10.6
Keywords	16
Detailed Specifications and Photographs of Apparatus	Annex A1
ICS Codes	75.160.20 - Liquid fuels

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D6201:2001 Edition

Related products