ASTM-D7042 2012

$40.63

D7042-12 Standard Test Method for Dynamic Viscosity and Density of Liquids by Stabinger Viscometer (and the Calculation of Kinematic Viscosity)

Published By	Publication Date	Number of Pages
ASTM	2012	9

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers and specifies a procedure for the concurrent measurement of both the dynamic viscosity, ? , and the density, ? , of liquid petroleum products and crude oils, both transparent and opaque. The kinematic viscosity, ? , can be obtained by dividing the dynamic viscosity, ? , by the density, ? , obtained at the same test temperature.

1.2 The result obtained from this test method is dependent upon the behavior of the sample and is intended for application to liquids for which primarily the shear stress and shear rate are proportional (Newtonian flow behavior).

1.3 The precision has only been determined for those materials, viscosity ranges, density ranges, and temperatures as indicated in Section 15 on Precision and Bias. The test method can be applied to a wider range of materials, viscosity, density, and temperature. For materials not listed in Section 15 on Precision and Bias, the precision and bias may not be applicable.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Summary of Test Method Significance and Use Apparatus FIG. 1
3	Reagents and Materials Sampling, Test Specimens, and Test Units Calibration and Verification FIG. 2
4	Adjustment Procedure TABLE 1
5	Cleaning of the Measuring Cells Calculation of Results Report Precision and Bias
6	TABLE 2 TABLE 3
7	Keywords A1. CALCULATION OF ACCEPTABLE TOLERANCE ZONE A1.1 A1.2 A1.3 A1.4
8	X1.1 X1.2 X2.1 X2.2 TABLE X1.1 TABLE X2.1

Additional information

Standard Title	D7042-12 Standard Test Method for Dynamic Viscosity and Density of Liquids by Stabinger Viscometer (and the Calculation of Kinematic Viscosity)
Published Code	ASTM
Publication Date	2012
Pages Count	9

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D7042 2012

PDF Catalog

Related products