ASTM-D7575 2011

$44.96

D7575-11 Standard Test Method for Solvent-Free Membrane Recoverable Oil and Grease by Infrared Determination

Published By	Publication Date	Number of Pages
ASTM	2011	12

Guaranteed Safe Checkout

Categories: 13.060.50 - Examination of water for chemical substances, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers the determination of oil and grease in produced and waste water samples over the concentration range outlined in Table 1 that can be extracted with an infrared-amenable membrane and measured by infrared transmission through the membrane.

1.2 This method defines oil and grease in water as that which is extractable in the test method and measured by infrared transmission.

1.3 The method detection limit (MDL) and recommended reporting range are listed in Table 1.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

TABLE 1 MDL and Reporting Range

^A MDL and recommended reporting range determined by Section 12.4, which follows the Code of Federal Regulations, 40 CFR Part 136, Appendix B; limits should be determined by each operator.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method TABLE 1
2	Significance and Use Interferences Apparatus Reagents and Materials
3	Hazards Sampling Preparation of Apparatus Calibration and Standardization
4	TABLE 2
5	Preparation of Infrared Instrument Procedure Calculation or Interpretation of Results Report
6	Precision and Bias Keywords TABLE 3 TABLE 4
7	TABLE 5 TABLE 6 TABLE 7
8	X1. DETERMINING MEMBRANE DRYNESS SPECTROSCOPICALLY X1.1 TABLE 8 TABLE 9 TABLE 10 TABLE 11
9	FIG. X1.1
10	FIG. X1.2
11	FIG. X1.3
12	FIG. X1.4