🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-E1827:2002 Edition

ASTM-E1827:2002 Edition

$44.96

E1827-96(2002) Standard Test Methods for Determining Airtightness of Buildings Using an Orifice Blower Door

Published By Publication Date Number of Pages
ASTM 2002 12
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 These test methods describe two techniques for measuring air leakage rates through a building envelope in buildings that may be configured to a single zone. Both techniques use an orifice blower door to induce pressure differences across the building envelope and to measure those pressure differences and the resulting airflows. The measurements of pressure differences and airflows are used to determine airtightness and other leakage characteristics of the envelope.

1.2 These test methods allow testing under depressurization and pressurization.

1.3 These test methods are applicable to small indoor-outdoor temperature differentials and low wind pressure conditions; the uncertainty in the measured results increases with increasing wind speeds and temperature differentials.

1.4 These test methods do not measure air change rate under normal conditions of weather and building operation. To measure air change rate directly, use Test Methods E 741.

1.5 The text of these methods reference notes and footnotes that provide explanatory material. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 7.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
3 Summary of Test Methods
Significance and Use
Apparatus
4 Hazards
Procedure
FIG. 1
5 Data Analysis and Calculations
TABLE 1
7 Report
Precision and Bias
8 Keywords
A1. CALIBRATION OF FLOW MEASUREMENT DEVICE
A1.1
A1.2
A1.3
A2. CALIBRATION OF PRESSURE MEASUREMENT DEVICE
A2.1
A2.2
A3. ANALYSIS OF PRECISION AND BIAS ERRORS
A3.1
TABLE A3.1
9 A3.2
A3.3
10 A4. EQUATIONS IN INCH-POUND UNITS
A4.1
A4.2
A4.3
A4.4
A4.5
A4.6
A4.7
11 A5. CALCULATION OF DYNAMIC VISCOSITY
A5.1
X1. RECOMMENDED PRECISION AND BIAS
X1.1
X1.2
X2. SAMPLE CALCULATIONS
X2.1
X2.2
X2.3
TABLE X1.1
TABLE X1.2
12 X2.4
TABLE X2.1

Related products

ASTM-E1827
$44.96