ASTM-E2092 2013(Redline)

$29.90

E2092-13 Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis (Redline)

Published By	Publication Date	Number of Pages
ASTM	2013	7

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method describes the determination of the temperature at which the specific modulus of a test specimen is realized by deflection in three-point bending. This temperature is identified as the distortion temperature. The distortion temperature is that temperature at which a test specimen of defined geometry deforms to a level of strain under applied stress of 0.455 MPa (66 psi) (Method A) and 1.82 MPa (264 psi) (Method B) equivalent to those used in Test Method D648. The test may be performed over the range of temperature from ambient to 300°C.

Note 1—This test method is intended to provide results similar to those of Test Method D648 but are performed on a thermomechanical analyzer using a smaller test specimen. Equivalence of results to those obtained by Test Method D648 has been demonstrated on a limited number of materials. The results of this test method shall be considered to be independent and unrelated to those of Test Method D648 unless the user demonstrates equivalence.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

1.4 There is no ISO standard equivalent to this test method.

Additional information

Standard Title	E2092-13 Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis (Redline)
Published Code	ASTM
Publication Date	2013
Pages Count	7

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-E2092 2013(Redline)

Related products