ASTM-E2254 2011

$35.75

E2254-11 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers

Published By	Publication Date	Number of Pages
ASTM	2011	3

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E2254-11

Historical Standard: Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers

ASTM E2254

Scope

1.1 This test method describes the calibration or performance confirmation for the storage modulus scale of a commercial or custom built dynamic mechanical analyzer (DMA) over the temperature range of -100 to 300 °C using reference materials in the range of 1 to 200 GPa.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

calibration; conformity; dynamic mechanical analysis; storage modulus; Calibration–laboratory analysis instrumentation; Conformity; Dynamic mechanical analysis (DMA); Storage modulus

ICS Code

ICS Number Code 17.020 (Metrology and measurement in general)

DOI: 10.1520/E2254-11

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use Apparatus
2	Reagents and Materials Sampling Calibration and Standardization Procedure Calculation TABLE 1
3	Report Precision and Bias Keywords

Additional information

Standard Title	E2254-11 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
Published Code	ASTM
Publication Date	2011
Pages Count	3