ASTM-E2375 2008

$58.50

E2375-08 Standard Practice for Ultrasonic Testing of Wrought Products

Published By	Publication Date	Number of Pages
ASTM	2008	24

Guaranteed Safe Checkout

Categories: 71.040.99 - Other standards related to analytical chemistry, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 Purpose This practice establishes the minimum requirements for ultrasonic examination of wrought products.

Note 1This standard was adopted to replace MIL-STD-2154, 30 Sept. 1982. This standard is intended to be used for the same applications as the document which it replaced. Users should carefully review its requirements when considering its use for new, or different applications, or both.

1.2 Application This practice is applicable for examination of materials such as, wrought metals and wrought metal products.

1.2.1 Wrought Aluminum Alloy Products Examination shall be in accordance with Practice B 594 .

1.3 Acceptance Class When examination is performed in accordance with this practice, engineering drawings, specifications, or other applicable documents shall indicate the acceptance criteria. Five ultrasonic acceptance classes are defined in Table 1. One or more of these classes may be used to establish the acceptance criteria or additional or alternate criteria may be specified.

1.4 Order of Precedence Contractual requirements and authorized direction from the cognizant engineering organization may add to or modify the requirements of this practice. Otherwise, in the event of conflict between the text of this practice and the references cited herein, the text of this practice takes precedence. Nothing in this practice, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.5 Measurement Values The values stated in inch-pounds are to be regarded as standard. The metric equivalents are in brackets.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology TABLE 1
3	Significance and Use Basis of Application General Requirements Detail Requirements
5	FIG. 1
6	TABLE 2 TABLE 3
7	TABLE 4
8	TABLE 5
9	FIG. 2
10	FIG. 3 FIG. 4
11	FIG. 5
12	FIG. 6
13	FIG. 7
15	Government Contracts
16	Keywords A1. ANGLE BEAM EXAMINATION A1.1 Scope A1.2 General Requirements A1.3 Examination Requirements
17	FIG. A1.1
18	FIG. A1.2
19	FIG. A1.3
20	FIG. A1.4
21	FIG. A1.5
22	A2. EXAMINATION REPORTS TECHNICAL REQUIREMENTS A2.1 Scope A2.2 Applicable Documents A2.3 Reports A3. GAIN CONTROL, ATTENUATOR CALIBRATION, AND LINEARITY CHECK A3.1 A3.2 Gain Control and Attenuator Calibration
23	A3.3 Linearity Check A4. MEASUREMENT OF LENGTH OF LINEAR INDICATION A4.1 Scope TABLE A3.1

Additional information

Standard Title	E2375-08 Standard Practice for Ultrasonic Testing of Wrought Products
Published Code	ASTM
Publication Date	2008
Pages Count	24
ICS Codes	71.040.99 - Other standards related to analytical chemistry

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-E2375 2008

PDF Catalog

Related products