Shopping Cart

No products in the cart.

ASTM-E2515:2011 Edition

$44.96

E2515-11 Standard Test Method for Determination of Particulate Matter Emissions Collected by a Dilution Tunnel

Published By Publication Date Number of Pages
ASTM 2011 15
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

1.1 This test method is applicable for the determination of particulate matter emissions from solid-fuel-burning appliances including woodstoves, pellet-burning appliances, factory-built fireplaces, masonry fireplaces, masonry heaters, indoor furnaces, and indoor and outdoor hydronic heaters within a laboratory environment.

1.2 Analytes will be a particulate matter (PM) with no CAS number assigned. For data quality objectives, see Appendix X1.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.4 This test method does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Summary of Test Method
2 Safety
Equipment and Supplies
FIG. 1
3 FIG. 2
4 FIG. 3
FIG. 4
5 Reagents and Standards
Calibration and Standardization
Procedures
7 FIG. 5
FIG. 6
8 FIG. 7
9 FIG. 8
10 Analytical Procedure
Data Analysis and Calculations
12 Precision and Bias
13 X1. MEASUREMENT UNCERTAINTY
X1.1 Total Emissions Measurement Uncertainty
X1.2
X1.3 Measurement Uncertainty Analysis
15 X2. STANDARD PITOT TUBE
X2.1
FIG. X2.1
ASTM-E2515
$44.96