ASTM-E3301:2022 Edition

$29.79

E3301-22 Standard Test Method for Temperature Calibration of Dynamic Mechanical Analyzers Using Thermal Lag

Published By	Publication Date	Number of Pages
ASTM	2022	4

Guaranteed Safe Checkout

Categories: 17.200.01 - Thermodynamics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E3301-22

Active Standard: Standard Test Method for Temperature Calibration of Dynamic Mechanical Analyzers Using Thermal Lag

ASTM E3301

Scope

1.1 This test method describes the temperature calibration of a dynamic mechanical analyzer using thermal lag over the temperature range of –100 °C to 300 °C.

1.2 This standard may be compared to Test Methods E1867.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

calibration; dynamic mechanical analyzer; thermal analysis; thermal lag;

ICS Code

ICS Number Code 17.200.01 (Thermodynamics in general)

DOI: 10.1520/E3301-22

Additional information

Standard Title	E3301-22 Standard Test Method for Temperature Calibration of Dynamic Mechanical Analyzers Using Thermal Lag
Published Code	ASTM
Publication Date	2022
Pages Count	4
ICS Codes	17.200.01 - Thermodynamics in general