Shopping Cart

No products in the cart.

ASTM-F1388:2000 Edition

$40.63

F1388-92(2000) Standard Test Method for Generation Lifetime and Generation Velocity of Silicon Material by Capacitance-Time Measurements of Metal-Oxide-Silicon (MOS) Capacitors (Withdrawn 2003)

Published By Publication Date Number of Pages
ASTM 2000 7
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM F1388-92-Reapproved2000

Withdrawn Standard: Standard Test Method for Generation Lifetime and Generation Velocity of Silicon Material by Capacitance-Time Measurements of Metal-Oxide-Silicon (MOS) Capacitors (Withdrawn 2003)

ASTM F1388

Scope

This standard was transferred to SEMI (www.semi.org) May 2003

1.1 This test method covers the measurement of generation lifetime and generation velocity of silicon wafers.

1.2 The measurement requires the fabrication of a guard-ring MOS (Metal-Oxide-Silicon) capacitor. This test method is therefore destructive to the silicon wafer.

1.3 This test may also be applied to semiconductor materials other than silicon and to insulators other than silicon dioxide, but the details of capacitor fabrication and the analyses and interpretation of data in such cases are not given in this test method.

1.4 Both p– and n-type silicon in the doping range from 1013 to 10 17 cm-3 can be evaluated by this test method. The approximate range of generation lifetime that can be measured is 1µs to 10 ms.

1.5 The test method is applicable to both bulk and epitaxial silicon. If epitaxial silicon is used, the epitaxial layer must be of the same conductivity type as the substrate and should be at least twice as thick as the maximum depletion width in deep depletion to avoid errors caused by the proximity of the epitaxial interface (see 12.4).

1.6 It is necessary to complete the measurements described in Test Method F 1153 before performing the measurements described in this test method to determine the values of maximum capacitance, equilibrium minimum capacitance, and doping density.

1.7 A digital computer capable of controlling the instruments and recording data is required and significantly simplifies and improves the accuracy of the data acquisition and analysis process.

1.8 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in 11.5 and 11.8.

Keywords

capacitance-time measurements; C-t measurements; generation lifetime; lifetime; generation velocity; MOS capacitor; silicon

ICS Code

ICS Number Code 31.060.01 (Capacitors in general)

DOI: 10.1520/F1388-92R00

ASTM-F1388
$40.63