Shopping Cart

No products in the cart.

ASTM-F1901:2004 Edition

$40.63

F1901-98(2004) Standard Specification for Polyethylene (PE) Pipe and Fittings for Roof Drain Systems

Published By Publication Date Number of Pages
ASTM 2004 7
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM F1901-98-Reapproved2004

Historical Standard: Standard Specification for Polyethylene (PE) Pipe and Fittings for Roof Drain Systems

ASTM F1901

Scope

1.1 This specification covers requirements for polyethylene (PE) pipe and fittings for nonpressure roof drain systems.

1.2 This specification covers pipe and fittings intended for normal residential and commercial uses and is not intended for use in unusual corrosive conditions.

Note 1

Before installing pipe for waste disposal use, the approval of the cognizant building code authority shall be obtained as conditions not found in normal use or temperatures approaching 140°F (60°C) may be encountered.

1.3 Pipe is produced in dimensions based on outside diameters of 32 mm (1.250 in.) and larger in accordance with Specification F 714.

1.4 The interchangeability of pipe and fittings made by different manufacturers is not addressed in this specification. Transition fittings for joining pipe and fittings of different manufacturers is provided for in this specification.

1.5 Pipe and fittings are joined by the heat-fusion method, by the electrofusion method, or by using mechanical joints (excluding insert fittings) recommended by the manufacturer.

1.6 In referee decisions, the SI units shall be used for metric-sized pipe and inch-pound units for pipe sized in the IPS system (ANSI B36.10). In all cases, the values given in parentheses are provided for information only.

The following safety hazards caveat pertains only to the test method, Section , of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

DWV; pipe fittings; plastic pipes; polyethylene; recycle; waste disposal (building)

ICS Code

ICS Number Code 23.040.01 (Pipeline components in general. Pipelines)

DOI: 10.1520/F1901-98R04

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
2 Terminology
Materials and Manufacture
Requirements
TABLE 1
TABLE 2
TABLE 3
3 Workmanship, Finish and Appearance
TABLE 4
4 Test Methods
Retest and Rejection
Product Marking
5 Quality Assurance
Keywords
A1. INSTRUCTIONS
A1.1
A1.2
6 X1. STORAGE
X1.1 Outside Storage
X1.2
X2. JOINING
X2.1 Field Inspection
X2.2 Pipe Fit
X2.3
X2.4 Cutting
X2.5 Cleaning
X3. INSTALLATION
X3.1 Installation Under Freezing Conditions
X3.2 Alignment and Grade
X3.3 Supports and Spacing
X3.4 Threaded Connections
X3.5 Threaded Tightness
X3.6 Connection to Nonplastic Pipe
X3.7 Thermal Expansion
X3.8 Chemical Resistance
ASTM-F1901
$40.63