ASTM-F2206 2014

$31.25

F2206-14 Standard Specification for Fabricated Fittings of Butt-Fused Polyethylene (PE)

Published By	Publication Date	Number of Pages
ASTM	2014	5

Guaranteed Safe Checkout

Categories: 23.040.20 - Plastics pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F2206-14

Historical Standard: Standard Specification for Fabricated Fittings of Butt-Fused Polyethylene (PE)

ASTM F2206

Scope

1.1 This specification establishes requirements for fabricated fittings intended for use with outside-diameter controlled polyethylene pipe and tubing. These fittings are manufactured by heat-fusion joining shape-modified polyethylene components prepared from pipe, molded fittings, sheet, billet, or block. Included are requirements for materials, design, workmanship, minimum dimensions, marking, test methods, and quality control.

1.2 Pressure rating of the fabricated-fitting design is beyond the scope of this standard and shall be established by the fitting manufacturer. This specification includes requirements for both elevated temperature pressure-tests and short-term pressurization tests to demonstrate a reasonable level of performance of the fabricated-fitting design at the pressure rating established by the fitting manufacturer.

1.3 The pressure-tests requirements are specified by the fittings’ equivalent (E) DR. The EDR specified is the DR of the piping system for which the fabricated fitting is intended to be butt-fused.

1.4 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.5 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units which are provided for information only and are not considered standard.

1.6 The following safety hazards caveat pertains only to the test methods portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

fabricated fittings; polyethylene;

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/F2206-14

Additional information

Standard Title	F2206-14 Standard Specification for Fabricated Fittings of Butt-Fused Polyethylene (PE)
Published Code	ASTM
Publication Date	2014
Pages Count	5
ICS Codes	23.040.20 - Plastics pipes