ASTM-F2527 2010

$40.63

F2527-10 Standard Specification for Wrought Seamless and Welded and Drawn Cobalt Alloy Small Diameter Tubing for Surgical Implants (UNS R30003, UNS R30008, UNS R30035, UNS R30605, and UNS R31537)

Published By	Publication Date	Number of Pages
ASTM	2010	6

Guaranteed Safe Checkout

Categories: 11.040.40 - Implants for surgery, prosthetics and orthotics, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers the requirements for wrought seamless and welded and drawn cobalt alloy small diameter tubing used for the manufacture of surgical implants. Material shall conform to the applicable requirements of Specifications F90 , F562 , F688 , F1058 or F1537 , Alloy 1. This specification addresses those product variables that differentiate small diameter medical tubing from the bar, wire, sheet and strip product forms covered in these specifications.

1.2 This specification applies to straight length tubing with 6.3 mm [0.250 in.] and smaller nominal outside diameter (OD) and 0.76 mm [0.030 in.] and thinner nominal wall thickness.

1.3 The specifications in 2.1 are referred to as the ASTM material standard(s) in this specification.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology General Requirements for Delivery Ordering Information Materials and Manufacture TABLE 1
3	Chemical Composition Mechanical Properties Dimensions and Permissible Variation
4	Permissible Outer and Inner Surface Imperfections Special Tests Significance of Numerical Limits Certification Quality Program Requirements Keywords TABLE 2
5	X1. RATIONALE X1.1 X1.2 X1.3 X1.4 Precision and Bias X1.5 X1.6 X1.7 X1.8 X1.9 Units of Measure
6	X1.10 Lot Definition X2. BIOCOMPATIBILITY X2.1

Additional information

Standard Title	F2527-10 Standard Specification for Wrought Seamless and Welded and Drawn Cobalt Alloy Small Diameter Tubing for Surgical Implants (UNS R30003, UNS R30008, UNS R30035, UNS R30605, and UNS R31537)
Published Code	ASTM
Publication Date	2010
Pages Count	6
ICS Codes	11.040.40 - Implants for surgery, prosthetics and orthotics

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-F2527 2010

PDF Catalog

Related products