ASTM-F788 2008

$40.63

F788/F788M-08 Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series

Published By	Publication Date	Number of Pages
ASTM	2008	6

Guaranteed Safe Checkout

Categories: 21.060.10 - Bolts, screws, studs, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs, including heat-treated machine screws, tapping screws, and sems (the washers of screw-washer assemblies are excluded). This specification covers metric series products with nominal diameters of 4 mm and larger and with specified minimum tensile strengths of 420 MPa and higher; and inch series products with nominal diameters of No. 5 (0.1250 in.) and larger and with specified minimum tensile strengths of 60 000 psi and higher.

1.2 When the engineering requirements of the application necessitate control of surface discontinuities on bolts, screws, or studs, the purchaser shall specify conformance to ASTM Specification F 788/F 788M, in the original inquiry and purchase order.

1.2.1 When the engineering requirements of the application necessitate that surface discontinuities on bolts, screws, and studs be controlled within limits closer than those specified in this specification, the purchaser shall specify the applicable limits in the original inquiry and purchase order.

1.3 The allowable limits established in this specification for metric bolts, screws, and studs with nominal diameters from 4 to 24 mm inclusive, are essentially identical with requirements given in ISO 6157/I. There are no ISO standards for surface discontinuities on any inch-series products.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Ordering Information Types of Surface Discontinuities (see Terminology for definitions not provided)
2	Allowable Limits FIG. 1 FIG. 2
3	FIG. 3 FIG. 4 FIG. 5
4	Inspection and Evaluation Keywords FIG. 6 FIG. 7
5	TABLE 1 FIG. S1.1
6	FIG. S1.2

Additional information

Standard Title	F788/F788M-08 Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series
Published Code	ASTM
Publication Date	2008
Pages Count	6
ICS Codes	21.060.10 - Bolts, screws, studs

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-F788 2008

PDF Catalog

Related products