AWWA C153 2011

$75.83

AWWA C153-11: Ductile-Iron Compact Fittings For Water Service

Published By	Publication Date	Number of Pages
AWWA	2011	52

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard describes 3-in. through 64-in. (80-mm through 1,600-mm) ductile-iron compact fittings to be used with ductile-iron pipe or pipe made of other materials with similar outside diameters for conveying potable water, wastewater and reclaimed water.

PDF Catalog

PDF Pages	PDF Title
1	ANSI/AWWA C153/A21.53-11
3	Committee Personnel
7	Contents
9	Foreword I. Introduction.
12	II. Special Issues.
13	III. Use of This Standard.
14	IV. Major Revisions. V. Comments.
15	AWWA Standard Ductile-Iron Compact Fittings SECTION 1: GENERAL Sec. 1.1 Scope
16	Sec. 1.2 Purpose Sec. 1.3 Application SECTION 2: REFERENCES
17	SECTION 3: DEFINITIONS SECTION 4: REQUIREMENTS Sec. 4.1 Materials
18	Sec. 4.2 Permeation Sec. 4.3 General Requirements
19	Sec. 4.4 Coatings and Linings
20	Sec. 4.5 Tolerances or Permitted Variations
21	Sec. 4.6 Markings on Fittings Sec. 4.7 Special Requirements for Flanged Fittings
22	SECTION 5: VERIFICATION Sec. 5.1 Inspection Sec. 5.2 Test Procedures
23	Sec. 5.3 Chemical Limitations Sec. 5.4 Additional Tests Required by Purchaser Sec. 5.5 Performance Requirements
24	Sec. 5.6 Defective Specimens and Retests Sec. 5.7 Nonconforming Fittings Sec. 5.8 Affidavit of Compliance SECTION 6: DELIVERY
25	Table 1 Mechanical-joint by mechanical-joint bends
26	Table 2 Mechanical-joint by plain-end bends
27	Table 3 Mechanical-joint tees
28	Table 3 Mechanical-joint tees (continued)
29	Table 3 Mechanical-joint tees (continued)
30	Table 4 Mechanical-joint crosses
31	Table 4 Mechanical-joint crosses (continued)
32	Table 5 Mechanical-joint reducers (continued)
33	Table 5 Mechanical-joint reducers (continued)
34	Table 6 Mechanical-joint sleeves
35	Table 7 Mechanical-joint caps and Table 8 Mechanical-joint plugs
36	Table 9 Mechanical-joint tapped tees*
37	Table 10 Mechanical-joint and flange connecting pieces*
39	Table 11 Mechanical-joint offsets
41	Table 12 Push-on joint bends*
43	Table 13 Push-on joint tees and crosses*
44	Table 14 Push-on joint reducers*
45	Table 15 Flange details
46	Table 16 Flanged bends*
47	Table 17 Flanged tees and crosses*
48	Table 18 Flanged reducers*
49	APPENDIX A Flanged Fittings: Bolts, Gaskets, and Installation SECTION A.1: BOLTS AND NUTS SECTION A.2: GaskETS
50	Table A.1 Flange gasket details SECTION A.3: INSTALLATION