AWWA C562 2021

$76.92

AWWA C562-21 Fabricated Aluminum Slide Gates

Published By	Publication Date	Number of Pages
AWWA	2021	36

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

The purpose of this standard is to provide the minimum requirements for fabricated aluminum slide gates, including materials, general design, manufacture, testing, inspection, and shipment.

PDF Catalog

PDF Pages	PDF Title
7	Foreword I. Introduction. I.A. Background. A fabricated aluminum slide gate is a vertically sliding gate, fabricated from rolled or extruded aluminum shapes, with ultra-high-molecular-weight polyethylene (UHMW-PE) seating faces and seals or UHMW-PE seating faces and resilient rubb
8	I.B. History. The original AWWA standard for slide gates (then referred to as sluice gates) was approved as tentative on June 26, 1941, and described cast-iron gates. The tentative standard was revised and approved on June 4, 1967, as AWWA C501. Subsequen I.C. Acceptance. In May 1985, the US Environmental Protection Agency (USEPA) entered into a cooperative agreement with a consortium led by NSF International (NSF) to develop voluntary third-party consensus standards and a certification program for direct
9	II. Special Issues. II.A. Chlorine and Chloramine Degradation of Elastomers. The selection of materials is critical for water service and distribution piping in locations where there is a possibility that elastomers will be in contact with chlorine or chloramines. Documented
10	III. Use of This Standard. It is the responsibility of the user of an AWWA standard to determine that the products described in that standard are suitable for use in the particular application being considered. III.A. Purchaser Options and Alternatives. The following items should be provided by the purchaser:
11	III.B. Modification to Standard. Any modification to the provisions, definitions, or terminology in this standard must be provided by the purchaser. IV. Major Revisions. Major revisions made to the standard in this edition include the following: V. Comments. If you have any comments or questions about this standard, please call AWWA Engineering and Technical Services at 303.794.7711; FAX at 303.795.7603; write to the department at 6666 West Quincy Avenue, Denver, CO 80235-3098; or email at standa
13	AWWA Standard SECTION 1: GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose Sec. 1.3 Application
14	SECTION 2: REFERENCES
16	SECTION 3: DEFINITIONS
17	SECTION 4: REQUIREMENTS Sec. 4.1 Data to Be Provided by the Supplier Sec. 4.2 Data to Be Provided by the Manufacturer
28	Sec. 4.5 Manufacture
29	Sec. 4.6 Installation
31	Sec. 5.3 Basis for Rejection
32	Sec. 6.3 Affidavit of Compliance
33	APPENDIX A Force Required to Actuate Fabricated Aluminum Gates