BS 123600-003:2001
$142.49
System of quality assessment. Capability detail specification. Flex-rigid multilayer printed boards with through-connections
| Published By | Publication Date | Number of Pages |
| BSI | 2001 | 26 |
This British Standard specifies the capability qualifying component, its characteristics to be tested, the test methods and conditions to be applied and the requirements to be fulfilled for testing basic and additional capability, in relation to flex-rigid multilayer printed boards with through-connections. It is applicable for flex-rigid multilayer printed boards with through-connections made with the materials and surface finishes specified in clause 4.
This British Standard is a capability detail specification intended for use with the IECQ system of quality assessment for electronic components.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 2 | Committees responsible for this British�Standard |
| 3 | Contents |
| 7 | 1 Scope 2 Normative references |
| 8 | 3 Terms and definitions 3.1 referee method 4 Capability qualifying component 4.1 General 4.2 Base materials |
| 9 | Table 1 Base materials 4.3 Surface finishes Table 2 Metallic finishes |
| 10 | Table 3 Organic finishes 5 Range of capability approval |
| 11 | 6 Capability test programme 6.1 General 6.2 Other metallic surface finishes 6.3 Organic surface finishes 6.4 Bonded stiffeners and rigidizers 7 Additional capability 7.1 Maximum active board size 7.2 Minimum conductor width and spacing 7.3 Metallic conductor finishes 8 Traceability |
| 12 | Table 4 Capability approval test schedule and performance requirements — General |
| 17 | Table 5 Capability approval test schedule and performance requirements — Additional metallic conductor fi… |
| 19 | Table 6 Capability approval test schedule and performance requirements — Additional contact finishes |
| 20 | Table 7 Capability approval test schedule and performance requirements — Permanent organic finishes |
| 22 | Annex A (normative) Use of ANSI/IPC A-600F Table A.1 Capability approval test schedule — General and additional metallic conductor finishes |
| 23 | Table A.2 Capability approval test schedule — Printed contacts |
| 24 | Table A.3 Capability approval test schedule — Solder resist Table A.4 Capability approval test schedule — Flexible/flex-rigid printed boards |
