BS 3734-1:1997:2001 Edition
$86.31
Rubber. Tolerances for products – Dimensional tolerances
| Published By | Publication Date | Number of Pages |
| BSI | 2001 | 14 |
Specifies classes of dimensional tolerances and their values, for moulded, extruded, and calendered solid rubber products. The relevant test methods are also specified.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 2 | Committees responsible for this British�Standard |
| 3 | Contents |
| 5 | Introduction 1 Scope 2 Normative references 3 Measurement of dimensions 3.1 General |
| 6 | 4 Tolerances 5 Mouldings 5.1 General |
| 7 | 5.2 Classification 5.3 Fixed dimensions and closure dimensions 5.4 Tolerances Figure 1 Compression mould and moulded part (diagrammatic) |
| 8 | Table 1 Tolerances for mouldings 5.5 Flash Table 2 Classes of flash 6 Extrusions 6.1 General |
| 9 | 6.2 Classification 6.3 Tolerances |
| 10 | Table 3 Tolerances on cross-sectional dimensions of unsupported extrusions Table 4 Tolerances on internal dimensions of mandrel-supported extrusions |
| 11 | Table 5 Tolerances on outside dimensions of surface-ground extrusions Table 6 Tolerances on wall thickness of surface-ground extrusions Table 7 Tolerances on cut length of extrusions |
| 12 | Table 8 Tolerances on thickness of cut sections of extrusions 7 Calendered sheet 7.1 General 7.2 Classification 7.3 Tolerances |
| 13 | Table 9 Tolerances on thickness of calendered sheet Table 10 Tolerances on width of calendered sheet |
